SB-WM46NA
Installation Instructions
2
DISCLAIMER
SunBriteTV LLC (SBTV) intend to make this manual accurate
and complete. However, SBTV makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this product. The
information contained in this document is subject to change
without notice or obligation of any kind. SBTV makes no
representation of warranty, expressed or implied, regarding the
information contained herein. SBTV assumes no responsibility
for accuracy, completeness or sufficiency of the information
contained in this document.
SunBriteTV® is a registered trademark of SunBrite TV LLC.
Built to SunBriteTV® specifications by Chief Manufacturing. All
rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm). Do
not install drywall anchors into the seam between drywall
pieces.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the SB-WM46NA up to (and
including) the display does not exceed 175 lbs (80 kg).
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
IMPORTANT ! :
The SB-WM46NA mounts are designed to be
mounted to a 2" x 4" wood studs (16" on center) wall.
--SAVE THESE INSTRUCTIONS--
