Attention New Spa Owner!
Congratulations on the purchase of your new Sundance
®
spa! The following
is a list of automated functions and maintenance recommendations for
your new spa. Automated functions have been listed below in an attempt
to suppress any operational concerns you may have during startup and the
first 24-hours of ownership! Maintenance recommendations are listed in an
attempt to stress their importance in protecting your new spa.
Automated Operations
Approximately two minutes after power is applied to the spa, the first filtration/
heating cycle turns on pump 1 (Section 9.0, page
). An automatic five minute
“blow-out” function also activates pump 2 for a period of five minutes to flush
all lines. Then, after five minutes, pump 2 turns off and pump 1 continues to
operate for the duration of the cycle.
Note:
This function only occurs during the first filtration/heating cycle each day.
Maintain Healthy Spa Water
Always maintain your hot tub’s water chemistry within the following
parameters as defined by the Association of Pool and Spa Professionals/USA:
pH
7.4-7.6
Free chlorine
3.0-4.0 ppm
Free bromine
2.0-4.0 ppm
Total Alkalinity
100-120 ppm
Calcium Hardness
150-250 ppm
!
TO dECREASE RISK OF INFECTION OR dISEASE!
Always
maintain your spa filter as outlined below to ensure healthy spa water.
Refer to pages 35
for additional information.
Required Filter Maintenance
Your new hot tub is equipped with an advanced 2-stage MicroClean
™ water
filtration system that provides unsurpassed water quality! To ensure maximum
water quality at all times, you should clean and reuse the larger pleated filter
cartridge every month and replace (throw away) the smaller MicroClean filter
cartridge every 3 months, or earlier as necessary. The smaller MicroClean
filter cartridge is designed to be thrown away! Attempts to reuse this filter
cartridge may result in the re-release of unwanted particles back into the spa.
See pages 35
for detailed filter cartridge replacement instructions.
Required Water Maintenance
!
TO dECREASE RISK OF INFECTION OR dISEASE!
You should
replace the spa’s water every 3 months. The frequency depends on a number
of variables including frequency of use, number of users, and attention paid to
water quality maintenance. You will know it is time for a change when you
cannot control sudsing and/or you can no longer get the normal feel or
sparkle to the water, even though the key water balance measurements are
all within the proper parameters. See pages
3 for additional information.
Summary of Contents for CONSTANCE
