Page 28
ELITE SERIES
9.0 Operating Instructions
The spa control system has automatic functions that operate upon startup
and normal operation to protect the system. Upon power up, the readout
displays the following information:
1. Control panel displays current software release (e.g.
3.58).
2. Control panel displays “888” and all indicator LEDs are
lit, permitting visual inspection of all display segments
and indicator lights for proper operation.
3. After the initial start-up sequence ends, the actual
water temperature is displayed. If water temperature
at this time is less than the factory default temperature setting of 100°F
(38°C) and the spa is set to either of the standard filtration/heating
modes (page 33), the heater will turn on and run until the water tem
-
perature rises to the factory setting, then turn off.
Note:
It is common for the heater to turn on after the spa is first filled
because tap water is often very cold.
4. Approximately two minutes after power is applied to the spa, the first
filtration/heating cycle turns on pump 1. An automatic five minute
“blow-out” function also activates pump 2 for a period of five minutes
to flush all lines. Then, after five minutes, pump 2 turns off and pump 1
continues to operate for the duration of the cycle.
Note:
This function only occurs during the first filtration/heating cycle each
day.
9.1
Setting Water Temperature
The spa’s thermostat provides optimum control of water tem
-
perature. The temperature setpoint (set temperature) can be
adjusted from 65-104°F (18-40°C
). To raise the set temperature, press
the
WARMER
(
)
button. To lower the set temperature, press the
COOLER
(
)
bu
tton. The first press of either button displays the set
temperature. To access the overtemp feature that allows the spa to reach
106°F (41°C) follow the steps below (Fi
gure 1).
A. Press and hold the
WARMER
(
) button
then;
B. Press and hold the
jETS 1
(
1
) button at
the same time for 2 seconds. You will see
the temperature rise to 106°F (41°C) on the LED display. To lower
the temperature, press the
COOLER
(
) button.
C. When the overtemp has been activated, the white decimal point after
the last digit will flash on and off every second as an indicator for
being in the overtemp mode.
Note:
Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps above.
1.
2.
3.
1
2
A
B
C
Figure 1
Summary of Contents for CONSTANCE
