Page 19
8.5 Jets 1:
The sensor pad labeled
JETS 1
controls the
2-speed pump #1. Press once for low speed. Press a second
time for high speed. Press a third time to turn off.
8.6 Jets 2:
The sensor pad labeled
JETS 2
controls pump #2.
Note: this pump runs only in high speed.
8.7 Jets 3:
The sensor pad labeled
JETS 3
controls pump #3.
Note: this pump runs only in high speed.
Auto Turn Off
- Anytime a jet pump has been manually turned on, it will
automatically turn off after approximately 20 minutes. If at this time you
desire more jet operation you may simply turn the pump(s) back on.
8.8 Selecting The Desired Massage Action
Your Sundance spa is equipped to allow you to customize the
massage action you desire. Each model incorporates a mas-
sage selector(s) that allow you to customize the massage and
performance by diverting water between various jet systems.
Simply turn massage selector to position A (Combo), B, or C to divert water
pressure to various jet groups.
Note: The valve is designed to operate in posi-
tions A (Combo), B, and C for optimum performance. It is considered normal
for sound levels within the valve to vary between positions due to the large
amounts of water flowing through it! For optimum filtration benefits, leave the
valve in position A when spa is covered. Select position B or C for maximum
jet performance during spa use.
Note:
the footwell suction filters in your hot
tub (page 16) protect the diverter valve from debris entrapment/damage.
8.9 Adjusting Fluidix Intelli-Jets
The Fluidix Intelli-Jets in your new spa offer the advantage of no moving
parts and zero maintenance. They can also be adjusted for a high and low
impact massage, providing the ultimate massage! Each jet has its own
water volume and directional or oscillating flow adjustment. The jet’s outer
dial controls water volume (flow rate) and it’s center “mode disk” selects
either an oscillating or directional flow massage.
To Adjust Jets
1. Turn outer dial (A) clockwise to increase water volume.
Turn outer dial counterclockwise to decrease water
volume or to shut jet off.
2. Rotate center “mode disk” (B) clockwise to select a
non-oscillating water stream or turn counterclockwise to
select an oscillating stream at any angle.
B
C
A
A
B
