!
Safety instructions
Before starting sundrape
®
electric motors, group con-
trols and radio remote controls carefully read technical
instructions for connexion, mounting and operation.
In case of damages caused by disregarding these
instructions, the guarantee expires. For consequential
damages we do not
assume any responsibility.
Attention – to assure the security of persons and faci-
lities these instructions have to be observed absolute-
ly! File the instructions carefully!
This device is not designed for employees (including
kids) with limited physical or mental skills or sensory
perception or for persons with a lack of experience or
knowledge, unless they are supervised by a person
who is responsible for their security or unless they
received instructions how to use the device.
Children are not allowed to play with stationary con-
trols and electrical systems. Keep radio remote control
devices away from children! Kids should be watched to
make sure that they do not play with the device.
The system has to be checked regularly on signs of
wear or damaged electrical lines.
Attention – inadequate mounting can cause severe
injuries!
Before you start maintenance work on electrical blinds,
always cut off power supply. The same applies to win-
dow cleaning work, if contact of humidity and cleaning
agents with the electrical systems is possible.
Connexion instructions for
sundrape
®
electric motors
Connexions and supply lines have to be passed
on site by authorized electricians according to
VDE (German Electrical Engineering Association)
and local EVU (electric supply company) instruc-
tions.
For controls of two and more motors a group
control is required. Cable laying plans and wiring
diagrams for group and central controls as well
as remote controls can be submitted on request.
Switch off unused lines and systems before you
connect the motor. Place push-buttons above a
height of 1,5 m near the system.
Allowed running periods and torques have to
correspond with the motor’s technical data.
In order to avoid backing ups of condensers
of running motors, parallel connexion of two
or more motors at one exit is prohibited. For
decoupling purposes a separate contact for
each direction of rotation is required.
Use only mechanically or electrically locked
switches and push-buttons. Switches and
controls may not permit concurrent up and
down operation! The time to change the
running direction from up/down to down/up
has to be at a minimum of 0,5 seconds. This
applies also for programmable control devi-
ces.
