Safe operation
To ensure safe and reliable operation of the devices, please
observe the following requirements:
Use the device only for its intended purpose
Do not use devices that show signs of malfunctioning
Avoid strong physical impacts on the device
Protect devices and cables from contact with moisture or other corrosive liquids
Whenever a fault is detected in the device, please contact the manufacturer.
General information
LEDGate series is compact drivers with DMX512 inputs with ability to control and dim 4 PWM output
lines for direct connection with LED equipment: duralight, driverless LED luminaires, etc, with independent
short-circuit protection on each channel, and a smooth verified dimming characteristic that completely
eliminates the effect of flickering, and can also operate in both 8 and 16 bit control modes. LEDGate
built-in battery-powered restart protection mode which eliminates the gating effect when the battery
is discharged, and thanks to innovative embedded algorithms, LEDGate provides a smooth, stepless
regulation in full range of intensity. The driver is configured and monitored using the RDM protocol
(ANSI E1.20) or by means of rotary switches installed on the device. LEDGate series is powered by DC 12-24 V.
Modifications
Installation
Before mounting and power up, it is necessary to verify protective earthing and cable connections.
1. Ensure the device has no damage due to transportation.
2. Fix the device on the surface. If you are using wireless modification, connect the antenna.
3. Connect the power cable, input DMX line and LED stripes. If you want connect slave devices,
connect LEDGate Compact Slave to Slave Out connector. If you use Wireless LEDGate Compact
and connect both DMX and BeDMX, priority has DMX. For connection via BeDMX, DMX line should
be disabled.
4. Set device address using DIP rotor switchers. Range of valid addresses starts with 001, (default)
and ends with 509. Starting with this address device will be controlled from an external remote.
LEDGate Compact Slave modification not equipped with DIP rotor switchers, starting address
for LEDGate Compact Slave devices equals the address of the previous device in the chain plus 4.
Product code
Name
Outputs
Wireless interface
Address switchers
LGC-1-D2LED
LEDGate
Compact
2
No
Yes
LGC-1-D4LED
LEDGate
Compact
4
No
Yes
LGC-1-DB2LED
Wireless
LEDGate Compact
2
Yes
Yes
LGC-1-DB4LED
Wireless
LEDGate Compact
4
Yes
Yes
LGCS-1-D2LED
LEDGate
Compact Slave
2
No
No
LGCS-1-D4LED
LEDGate
Compact Slave
4
No
No
LEDGate
3
Warning!
The device uses hazardous
voltage AC 90-250V