8057XTDLGYS
2
5/31/19
PROBLEM:
Drawers appear not to fit, do not slide in accurately and bump the cart sides.
SOLUTION:
The roller bearing slides must be fully engaged into the mounting slots on all drawers (see fig. 1 below). They
potentially could fall out of position during shipment. Check the side of the cart to determine which slide is out of position.
Remove the drawer that is out of position. The drawer is removed by the two clips on the actual roller bearing slide.
Simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides.
PROBLEM:
Back lock / unlock switch does not engage the drawer.
SOLUTION:
The inside lock / unlock slide potentially could fall out of its groove during shipment. Unscrew the four screws
that are holding the lock / unlock slide in place.
Once the screws are removed, simply place the latch back onto the slide and tighten the four screws back down.
Handle
Hardware
Caster
Hardware
4 pcs
16 pcs
4 pcs
16 pcs
4 pcs
16 pcs
Hardware Specifications:
TROUBLESHOOTING
8057XTDLGYS
PREMIUM FULL DRAWER
SERVICE CART
MOUNTING
SLOTS
FIG. 1
