SX80A
4
Rev. 05/09/03
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOLLOWING BEFORE USING THIS TOOL
•Tighten the gun to the cup securely with the nut and fitting supplied.
•Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should not
exceed 50 PSI.
•Adjust fluid control screw and spray width adjustment screw to your desired pattern before using
on production.
•Clean all parts after use.
SPRAYING
ADJUSTMENTS
In normal use, the nozzle wings are hor-
izontal as shown here. This
provides a vertical fan-shaped
pattern which gives maximum,
even, material coverage as the gun is
moved back and forth parallel to the sur-
face being finished.
Spray pattern may be infinitely
adjusted from round to flat.
Set inlet pressure at no more than 50 PSI. For optimum
performance, some materials may spray better at PSI
ratings below 50 PSI. If unsure, always test at PSI ratings
before using on final production. Try spray. If it is too
fine, decrease the air pressure or open fluid control
screw. If the spray is too thick, close the fluid control
screw. Regulate the pattern width and repeat adjustment
of spray as needed.
Fluid control screw
Turn right to decrease flow, left to increase.
HVLP
