8013ADELUXE/8013ABKDELUXE/8013ABLDELUXE Rev. A
2
7/3/14
Do not fully tighten fasteners
until prompted.
Step 1: Assembly preparation.
Clear table top and set Locking Drawer Assembly
on table top, with lid facing up. Position the Locking
Drawer Assembly so that one end hangs off of the
table enough to allow the chrome legs to go through
the square holes. Insert one set of chrome legs
through the overhanging holes as shown in Figure 1.
Do not bolt legs to top.
Step 2: Connecting legs and side
accessory to drawer assembly
Choose one of the side accessories (Pry Bar Holder
or Side Work Bench - Figure 2 shows Pry Bar Holder)
for attachment to the overhanging end of the service
cart. Align the outermost bolt holes in the accessory
with the bolt holes in the end of the cart and with
the uppermost holes in the chrome legs. Position a
washer and insert a 6mm bolt through the washer,
bolt holes, and legs as shown. Secure bolts with
a flat washer, lock washer, and nut on inside of
Locking Drawer Assembly. Tighten bolts until parts
fit together firmly.
Repeat steps 1 and 2 for other end of cart,
using remaining side accessory.
Locking
Drawer Assy.
Chrome
Legs
Table or
workbench
6mm
Bolt
Table or
workbench
Pry Bar
Holder
Chrome
Legs
Locking
Drawer Assy.
1.
2.
Locking
Top
Locking
Top
ASSEMBLY INSTRUCTIONS
NOTE
