EN - 6 -
•
When taking ice made in the ice making compartment, do not
touch it, ice may cause ice burns and/or cuts.
•
Do not touch frozen goods with wet hands! Do not eat ice-cream
and ice cubes immediately after you have taken them out of the
freezer compartment!
•
This product is intended for fresh food and drinks. Store fresh food
and drinks short-term.
•
Do not store frozen food and use to freeze food in the ice making
compartment.
•
Do not re-freeze frozen goods after they have melted. This may cause
health issues like food poisoning.
•
Do not use electrical devices, defrosting sprays or pointed or sharp-edged objects such
as knives or forks to remove the ice.
•
Do not cover the body or top of fridge with lace. This affects the performance of your
fridge.
•
Fix the accessories in the fridge during transportation to prevent damage to accessories.
•
Do not use plug adapter.
Installing and operating your fridge
Before starting to use your fridge, you should pay attention to the following points:
•
Operating voltage for your fridge is 220-240 V at 50Hz.
•
We do not take the responsibility of the damages that occur due to ungrounded usage.
•
Place your fridge in a place that it would not be exposed to direct sunlight.
•
Your appliance should be at least 50 cm away from stoves, Gas ovens and heater cores,
and should be at least 5 cm away from electrical ovens.
•
Your fridge should never be used outdoors or left under the rain.
•
When your fridge is placed next to a deep freezer, there should
be at least 2 cm between them to prevent humidity on the outer
surface.
•
Do not place anything on your fridge, and install your fridge in a
suitable place so that at least 15 cm is available on the upper side.
•
The adjustable front legs should be adjusted to make sure your appliance is level and
stable. You can adjust the legs by turning them clockwise (or in the opposite direction).
This should be done before placing food in the fridge.
•
Before using your fridge, wipe all parts back with warm water added with a tea spoonful
of sodium bicarbonate, and then rinse with clean water and dry. Place all parts after
cleaning.
•
Install the plastic distance guide (the part with black vanes at
the rear) by turning it 90° as shown in the figure to prevent the
condenser from touching the wall.
•
Refrigerator should be placed against a wall with a free distance
not exceeding 75 mm.