2
Sunflare Components List
• Metal Standing Seam Roof Width Requirement
In order for the PowerFit20 to be properly installed, the width between the internal
peaks of the seams must be no less than 15.5”. The PowerFit20 is only compatible
with flat standing seam roofs. Any striations or other non-flat surfaces may prevent the
module from adhering for the intended lifetime.
• WMS Spacer Tube
Specs: 203.2 x 50.8 x 25.4 mm
Description: PVC spacer tube used for
two functions: 1) as placement between
two adjacent modules and 2) as a way
to adhere the junction box to the roof.
The spacer tube comes with two sides of
adhesive to install onto the roof and the
bottom of the junction box cover.
• WMS Wire Conduit
Specs: 1675.0 x 31.75 x 31.75 mm
Description: PVC wire conduit that runs
parallel with the peak of each seam. It
will be justified to one side of the seam
and allow for a clean wiring for each
module to go to the roof cap. This piece
will be installed with the butyl-based
adhesive included with the component.
• WMS Junction Box Cover
Specs: 388.3 x 235.0 x 31.9 mm
Description: PVC junction box cover used
to house and protect the wiring between
two adjacent modules. It will be adhered
using DOW 804 adhesive to create a
water-tight seal.
31.75±2 mm
[1.25±0.1 in]
Profile View
Top-Down View
31.75±2 mm
[1.25±0.1 in]
1675.0±2 mm [65.9±0.1 in]
Profile View
Top-Down View
50.8±2 mm
[2.0±0.1 in]
R1.0
25.4±2 mm
[1.0±0.1 in]
25.4±2 mm
[1.0±0.1 in]
203.2±2 mm
[8.0±0.1 in]
Profile View
Top-Down View
235.0±2 mm
[9.25±0.1 in]
388.3±2 mm
[15.28±0.1 in]
25.86±2 mm
[10.2±0.1 in]
2.0±2 mm
[0.08±0.1 in]
32.15±2 mm
[1.27±0.1 in]
29.86±2 mm
[1.18±0.1 in]
31.86±2 mm
[1.25±0.1 in]
2.63°
142°
• 8” Jumper Cable
Specs: 8” long. 10AWG PV wire with
MC4 heads
Description: Pre-cut MC4 PV cabling for
an easy connection between two adjacent
modules. This cable will be housed
underneath the junction box cover.