BATTERY REPLACEMENT
HOW TO REPLACE THE BULB?
Input:
3V, 0.3W | Edison LED Bulb with E26 base
Step 1: Step 2 : Step 3 : Step 4:
Only use 3V, 0.3W LED bulbs. For more information on replacement bulbs, contact Sunforce Products Inc. at info@sunforceproducts.com or call 1-888-478-6435.
The solar string light's batteries (I) are
installed on the rear of the solar panel.
Always open the battery compartment with
the ON/OFF switch in the OFF position.
Unscrew the back of the battery compartment
and remove the backing piece. Inside you will
see the batteries.
When replacing the batteries, observe the
correct polarity and match the battery
specifications with the batteries you have
removed.
Use rechargeable batteries only.
Replace the back of the battery compartment
and continue to use the solar string lights as
required.
3V, CR2025 lithium button battery included.
Should you need to replace the included battery in the remote control, locate the battery
compartment on the edge of the remote control.
Push the tab to the right(1) and slide out the battery compartment (2).
Replace the battery ensuring the right polarity is observed and ensure the replacement battery has
the same characteristics as the one that has been removed.
AWARNING: This product contains a button battery. If swallowed, it could cause severe injury or
death in just 2 hours. Seek medical attention immediately.
Carefully unscrew the light bulb. Completely remove the light bulb. Carefully screw in the replacement bulb. Once the bulb is securely screwed into
place you are ready to use as required.
