21
4.3.2
Calibrating Accelerometer
Place the flight control as flat as possible. Push the throttle to highest, pull the elevator to
lowest and rudder the leftmost. The blue LED on the flight control board will blink for about
2 seconds and then stop. So the calibration is done.
For throttle at the right hand, pull/push the rocker arms as below:
For throttle at the left hand, pull/
push
the rocker arms like this:
4.4
Copter Lock & Unlock by Remote Control
4.4.1
Unlocking Copter
When the quadcopter is not unlocked yet, it cannot fly and you can only calibrate it. The
remote control still works on the plane, but for safety reason it is locked, in case of its going
out of control caused by maloperation on the remote.
How to unlock: Pull the throttle rocker arm to lowest, leave elevator in the middle, and push
the rudder to highest. You can see the LED on the flight control board lights up and glows a
steady blue. It is unlocked now! You can push the throttle and the copter will take off. About
unlocking:
Summary of Contents for 6D-Box
Page 17: ...14 Then click Tools Processor ATMega328 5V 16MHz ...
Page 32: ...29 ...