14
Later during the application, sometimes it may happen that the device cannot be
recognized. Don’t worry, just try to replug the USB cable, or reburn the firmware.
Configuring the Wizard of CC3D
Ensure the CC3D flight controller is kept connected to the computer, and double-click to
open the GCS just installed. The
TX
and
RX
data at bottom indicates the flight controller’s
connecting status. If they are both in grey, it means the flight controller is not connected.
Just replug to try.
Click
Vehicle Setup Wizard
and enter the interface of configuring the wizard as shown
below:
SunFounder