ROLLBOTMICRO
19
4)
Wait for a moment until the following information appears at the bottom of the window,
which indicates it is uploaded successfully.
5)
Remove the USB cable, switch on the power. Put the test card under the sensor module of
the robot. Press the
start button
for more than 2 seconds to enter the debugging mode. You
will see that in the OLED screen, there are five pillars simulating the signal intensity that the 5
sensors have collected. Now put the first sensor on the left in the black stripe. So the one
showing 1 has the strongest signal. As shown in figure below:
Start button
SunFounder