3
3.
Set the radio transmitter to open SWA, SWC auxiliary channel:
The four aux channels SWA, SWB, SWC, and SWD are not used in initial state, and we need to
apply SWA to arm the aircraft and SWC to shift flight mode on the debugged flight controller.
Thus, we need to open the aux channels first.
1)
Turn on the transmitter, follow the user manual of the transmitter to operate.
2)
Press and hold
OK
to enter the main menu, and press OK again to select the system setup as
shown below:
Press
DOWN
, and select
AUX switches
, and press OK to get into the interface below. Press and
hold
OK
, and the AUX switches will restore the default setting.
Press
OK
to select the aux channel, and
UP
or
DOWN
to turn it
ON
or
OFF
. Here we open two AUX
channels –
SWA
and
SWC
, and set
Ch
as
6
(The transmitter can be set to 6-10 channels; here 6 is
enough). Then press and hold
CANCEL
to exit and save the setting.
SunFounder
