63
Table 10-2
Analog control interface signal definition
S
Siig
gn
na
all
D
De
effiin
niittiio
on
n
1+，1-，2+，2-，3+，3-，4+，4-
4 analog input channels
The Logger1000 supports 4 inputs of 4～20mA analog currents or 4 inputs of 0～10V
analog voltage.
10.2.3 DRM Control Interface
The DRM control interface are located at the bottom of the Logger1000, as shown in the
figure below.
The DRM interface works together with DI1~DI4 to achieve the DRM function.
Wiring between the Logger1000 and the DRED is as follows:
The DRM interface requires that the Logger1000can be connected to the DRED via the
corresponding wiring terminal or RJ45 connector.
10.3 Power Control
Power regulation includes active power control and reactive power regulation.
10.3.1 Active Power
10.3.1.1 Disable
If the inverter needs to operate at full load, the active control mode should be set to
"Disable".
Step 1
Click "Power control" -> "Active power" to enter the active power interface.
User Manual
