3
2
Safety Instruction
This chapter mainly introduces safety instructions that need to be respected during the
operation of Logger1000.
The Logger1000 has been designed and tested strictly according to international safety
regulations. As electrical and electronic equipment, the Logger1000 must be installed,
commissioned, operated, and maintained in strict accordance with related safety
instructions.
Incorrect operation or work may cause:
•
injury or death to the operator or a third party;
•
damage to the Logger1000 and other properties.
Therefore, the following safety instructions must be read and always kept in mind prior
to any work. All detailed work-related safety warnings and notes will be specified at the
critical points in corresponding chapter.
All operation and electrical work must only be performed by qualified personnel.
B
Be
effo
orre
e IIn
nsstta
alllla
attiio
on
n
After receiving the device, please check if there is damage caused during
transport. Contact SUNGROW or the forwarding company once any problem is
detected.
The related operators must be familiar with the safety instructions in this manual
and other safety regulations about the installation, operation and maintenance
of the Logger1000.
Move, transport, install, operate, and maintain the Logger1000 correctly and
appropriately.
D
Du
urriin
ng
g IIn
nsstta
alllla
attiio
on
n
The Logger1000 can only be used as described in this manual. Altering the
product without authorization or using spare parts not sold or recommended by
SUNGROW may lead to fire, electric shock or other damages.
