62
9.9.14.2 Ethernet
Perform Ethernet settings on this interface.
step 1
Click "System" -> "Interface" -> "Ethernet" to enter the corresponding interface.
step 2
If auto IP allocation is
, the IP address of port ETH in invalid. Log in to the device
using the virtual IP address.
P
Po
orrtt
D
De
effa
au
ulltt IIP
P
V
Viirrttu
ua
all IIP
P
ETH
12.12.12.12
14.14.14.14
step 3
If the parameter "Automatically obtain IP settings (DHCP)" is set to
, fill in the
information such as the IP address, subnet mask, and default gateway, and click the
button
to save the operation.
-- -- E
En
nd
d
9.9.14.3 AI
step 1
Click "System" -> "Interface" -> "AI" to enter the corresponding interface.
step 2
Select an input type, set the lower limit and upper limit, and click the button
to save
the operation.
A
AII P
Po
orrtt
IIn
np
pu
utt T
Tyyp
pe
e
L
Lo
ow
we
err S
Sa
am
mp
plliin
ng
g
L
Liim
miitt
U
Up
pp
pe
err S
Sa
am
mp
plliin
ng
g
L
Liim
miitt
AI1
Voltage (V)
0
10
AI2
Current (mA)
4
20
AI3
Current (mA)
4
20
AI4
Current (mA)
4
20
step 3
If there is an external IO device connected to the logger, click “External” to set the AI
information of this device.
-- -- E
En
nd
d
9.9.14.4 DI
step 1
Click "System" -> "Interface" -> "DI" to enter the corresponding interface.
step 2
Set the initial status to "NO" or "NC", and click the button
to save the operation.
step 3
If there is an external IO device connected to the logger, click “External” to set the DI
information of this device.
-- -- E
En
nd
d
9.9.14.5 DO
step 1
Click "System"->"Port Parameter"->"DO" to enter the "Built-in" interface.
User Manual