63
step 2
Set the initial status of DO to “NO” or “NC”, and click
to set "Function", "Action
mode", and "Action time". Click
to save the settings.
step 3
If there is an external IO device connected to the logger, click "External" to set the DO
information of this device.
-- -- E
En
nd
d
9.9.15 MPLC
step 1
Click "System"->"MPLC" to enter corresponding interface.
step 2
Click
on the operation bar to set information of master and slave nodes.
-- -- E
En
nd
d
9.9.16 More
step 1
Click "System" -> "Port Parameters" -> "More" to enter the interface.
step 2
Select automatic online state (enable/disable) from the drop-down list.
•
When the state is set to "Enable", parameters of string inverters researched and
developed by SUNGROW can be automatically added without additional operations
on the Web.
•
When the state is set to "Disable", automatic parameter adding is not supported.
-- -- E
En
nd
d
9.9.17 About
Click "About" to enter the corresponding interface.
Firmware information on Logger4000 can be accessed on this interface.
Scan QR code on the interface with the iSolarCloud App, to add new Logger4000.
User Manual