25
5.5
Installing the Inverter
Inverter is installed on the wall by means of wall-mounting bracket and the expansion
plug sets.
The expansion plug set shown below is recommended for the installation.
(1) Self-tapping
screw M6
(2) Expansion tube
(3) Fender washer
(4) Spring washer
step 1
Place the wall-mounting bracket to a proper position on the wall. Mark the positions and
drill the holes.
Observe the level on the bracket and adjust until the bubble is in the middle
position.
The depth of the holes should be about 70 mm.
* The image shown here is for reference only. The actual product received may differ.
step 2
Place the expansion tubes into the holes. Then secure the wall-mounting bracket to the
wall firmly with the expansion bolt sets.
User Manual