© 2021 by Snow Joe
®
, LLC
All rights reserved. Original instructions.
SAVE THESE INSTRUCTIONS
2
A Division of Snow Joe
®
, LLC
OPERATOR’S MANUAL
Model 20ViONLTE-ST11-RM
Form No. SJ-20ViONLTE-ST11-RM-880E-M-V1
R
CORDLESS T EDGER
11-INCH | 20-VOLT
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Read all the instructions contained in this manual. Keep this
manual in a safe place, so that the information is available at
all times. If you give the equipment to another person, make
sure to provide these operating instructions. Basic safety
precautions should always be followed to reduce the risk of
fire, electric shock, and personal injury.
m
DANGER!
This indicates a hazardous situation, which,
if not followed, will result in serious injury or death.
m
WARNING!
This indicates a hazardous situation, which,
if not followed, could result in serious injury or death.
m
CAUTION!
This indicates a hazardous situation, which,
if not followed, could result in minor or moderate injury.
Improper use of the machine will invalidate the warranty,
relieve the manufacturer from all liabilities. The user will
consequently be liable for all and any damage or injury to
himself/herself or others.
m
DANGER!
The cordless t edger should only
be used for cutting lawns and for trimming along the borders
of flower beds. Other uses of the t edger that are
not indicated in these instructions could damage the unit or
seriously injure the operator.
General Safety
1. Avoid dangerous environments – Do not use appliances
in damp or wet locations. Do not use in rain.
2. Keep children and bystanders away – Children and
other spectators, including pets, should be kept at least
50 feet (15 meters) away from the work area. When the
grass is cut, stones and debris contained in the grass can
be picked up by the t edger and dispersed into
the air. These flying projectiles can cause blindness or
other bodily injury.
3. Dress properly – Always wear suitable clothing when
using the t edger to prevent head, hand, or feet
injuries. Do not wear loose clothing or jewelry. They can
get caught in moving parts.
4. Use safety glasses – Also use safety footwear, snug-
fitting clothing, protective gloves, hearing and
head protection.
5. Use the right tools –
Do not use tools for any job except
that for which they are intended.
6. Avoid unintentional starting – Do not carry the tool with
finger on the trigger. Make sure the switch is off before
inserting the battery.
7. Do not force the tool –
It will do the job better and with
less likelihood of injury if it is used at the rate for which it
was designed.
8. Do not overreach – Keep proper footing and balance at
all times.
9. Stay alert – Watch what you are doing. Use common
sense. Do not operate the t edger when you are
tired, or under the influence of alcohol or drugs.
10. Disconnect the tool –
Turn the t edger off and
remove the battery when: the unit is not in use; it is left
unattended; it is being examined because it is not working
correctly; the cutting line is being removed or changed; or
when the trimmer is being moved from one place
to another.
11. Store idle tools indoors – When not in use, tools should
be stored indoors in a dry and high or locked-up place out
of the reach of children.
12. Maintain tools with care – Keep cutting edges sharp
and clean for best performance and to reduce the risk
of injury. Follow instructions for lubricating and changing
accessories. Inspect the t edger periodically and
replace if damaged. Repair the t edger only at an
authorized service facility. Keep handles dry, clean, and
free from oil and grease.
13. Checked for damaged parts – Before continuing to
use the t edger, a guard or other part that is
damaged should be carefully checked to determine that
it will operate properly and perform its intended function.
Check for the alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any other
condition that may affect the tool’s operation. A guard or
other part that is damaged should be properly repaired or
replaced by an authorized service center unless indicated
elsewhere in this manual.
m
CAUTION!
The safety guard is critical to the safety of
the operator and the safety of people standing within a safe
distance of the t edger. The safety guard keeps the
unit in good working order and must always be in place during
operation. Failure to have the guard in place during operation
is dangerous and will void the warranty.
Summary of Contents for 20ViONLTE-ST11-RM
Page 20: ...20 NOTES ...
Page 21: ...21 NOTES ...
Page 22: ...22 NOTES ...
Page 24: ...sunjoe com ...
