6
can cause damage and will invalidate your guarantee.
USE ONLY A REPLACEMENT BATTERY AS SUPPLIED BY
THE MANUFACTURER
Replacement battery can be purchased from: Snow Joe, LLC.
Please call 1-866-766-9563; Email: service@snowjoe.com;
Website: www.snowjoe.com.
Cutting Height
m
CAUTION
:
For safety ensure that the Safety Key and Battery are
removed from the Mower before adjusting the height.
To ensure that the roller is aligned correctly, it is recommended
that the height is adjusted on a level surface. It is also
recommended that the Grass Collector be removed as this will
allow easier access to the Locking Knobs.
1.
Pull out the knobs on both sides of the roller. (Fig 11)
2.
Holding both knobs, raise or lower the mower to the
desired height.
3.
Allow the knobs to spring into the holes, ensure they sit
fully into the hole, are at the same height and properly
secured.
Battery Level Warning
This mower uses sealed Pb lead acid batteries, which like all
batteries can be damaged if they are over-discharged. The
electronic circuit will warn of low battery level and RED LED
will be on, this indicates that the battery should be recharged
at this point.
GREEN LED ON
–Normal operation.
RED LED ON
–Battery flat, please charge to prevent over
discharge damage.
Blade Adjustment
SHARP BLADES – BE VERY CAREFUL.
m
CAUTION
:
For safety ensure that the Safety Key and Battery are
removed from the Mower before adjusting the blade.
To adjust the blade turn the 2 bolts on the blade shield. The
cylinder should almost touch the blade, but do not over
tighten it. (Fig.13)
If the cylinder hits the blade,
it is too tight and will damage
the cutting edge; loosen
the nuts.
To check for correct
adjustment, insert a piece
of paper between the blade
and the cutting cylinder.
When the cutting cylinder
is turned by hand the paper
should be cut cleanly.
(Fig. 14)
Fig. 12
Fig. 11
Lower
Locking
Knob Pull Out
Raise
Cutting Cylinder
Fig. 13
Bolt
Bolt
Fig. 14
Blade
Paper
