3
Connecting Interchangeable
Heads
1. Press down the release button (Fig. 1).
2. Install tool attachment (tool head) on
the SUN JOE SwitchSTIK.
•
The release button (located in the
handle) must be held down while
installing the attachment.
•
The flats on the SwitchSTIK tip
must be aligned with the flats on the
attachment socket in order for the
SwitchSTIK to be fully engaged and
work properly (Fig. 2).
•
To align the flats, simply twist the
attachment while installing. The
attachment will bottom out on the
handle when the flats are properly
aligned and prevent the attachment
from rotating (Fig. 3).
m
CAUTION!
Do not push the
release button while using the SUN JOE
SwitchSTIK. Doing so could cause the
attachment to become disconnected and
serious injury could result.
SUN JOE SwitchSTIK Care
1. For optimal performance it is
important to keep the locking tip and
attachments free of dirt and debris.
Locking Tip: Rinse the locking tip
with water. DO NOT PUSH THE
RELEASE BUTTON. Doing so could
result in debris getting into the ball
joints impeding the performance of the
locking tip mechanism.
Attachments:
To remove debris, rinse
attachments with water.
Removing Interchangeable
Heads
1. Press down the release button
(located in the handle) (Fig. 4).
NOTE: The locking mechanism is
designed to be engaged at all times
and is only deactivated when the
release button is pressed.
2. Grasp tool attachment firmly, and
remove (Fig. 4).
NOTE:
The release button must
be held down while removing the
attachment.
Release button
Handle
Fig. 1
Fig. 2
Flats on the
SwitchSTIK tip
Flats on the
attachment
socket
Locking
mechanism
Handle
Tool attachment
Fig. 3
