16
Jump-starting a Vehicle Battery (Fig. 25)
IMPORTANT! If possible, park the vehicle as close to the
generator as possible.
1. Remove covers from the battery terminals.
2. Connect the red positive (+) jumper cable clamp to the
car's red positive (+) battery terminal.
3. Connect the other end of the red positive (+) jumper cable
clamp to the generator's red positive (+) battery terminal.
4. Connect the black negative (-) jumper cable clamp to the
generator's black negative (-) battery terminal.
5. Connect the other end of the black negative (-) jumper
cable clamp to a grounded metal area in the car away from
the battery and any moving parts.
6. Press and hold the ON/OFF button for approximately 1.5
second to turn on the generator, release when the unit
beeps.
7. Disconnect the jumper cables from both the vehicle and
the generator immediately once the vehicle has been
started.
8. Replace covers from battery terminals.
m
WARNING!
Prevent the red and black jumper cable
clamps from touching one another while both jaws of the other
end are still connected to a battery to prevent sparks and
damage to the battery.
Retractable Handle (Fig. 26)
1. Use your thumb to press the release button, then pull and
extend the telescoping handle.
2. To collapse the retractable handle, press the release
button, then push down.
Fig. 25
Back panel
Positive
terminal
Jumper cable clamps
Negative
terminal
Fig. 26
Release button
Retractable
handle
Summary of Contents for SJ1440SG-RM
Page 24: ...snowjoe com ...