sunjoe SJFP30, Operator'S Manual

4.

  Place the log grid on top of fire bowl followed by the 

protective screen and the screen hook (Fig. 4).

Care and Maintenance

Lighting

1. 

Make sure there is only a small amount of ash in the 

bottom of the bowl.

2. 

Place a layer of dry kindling or a natural fire-starter onto 

the center of the log grid. 

3. 

Above the kindling or fire-starter, place a layer of dry 

seasoned hardwood that is cut to lengths that are no  

more than 3/4 the diameter of the bowl.

4.

  Use a match to light kindling or fire-starter.

5.  Using the screen hook that is provided and heat-resistant 

gloves, replace the protective screen once the kindling or 

fire-starter is lit.

Tending the Fire

You may need to shift and/or add logs for an ideal fire pit

experience. DO NOT place a hot protective screen or hot fire 

pit tools onto combustible surfaces such as grass, wooden 

decks or furniture.

1.  Using the screen hook that is provided and heat-resistant 

gloves, carefully remove the protective screen.

2. 

Using a long-handled fire pit tool, shift the coals and logs 

to allow for additional air flow. 

3. 

DO NOT add gasoline, kerosene, diesel fuel, lighter fluid or 

alcohol to relight or enhance an existing fire.

4.

  Use a match to light the kindling or fire-starter.

5.  Wait until glowing coals have developed before adding 

any additional wood. If additional wood is required, place 

the wood on top of the coals, taking care not to shift the 

ashes.

Extinguishing

1.

  Let the fire burn itself out.

2.

  DO NOT use water to extinguish the fire. Such action is 

dangerous and can cause irreversible damage to the fire 

pit.

Inspecting

This fire pit should be inspected on a regular basis to ensure 

product safety and longer product life.

m 

DO NOT attempt to inspect this fire pit until the fire is 

COMPLETELY out and the fire pit has COMPLETELY cooled

. 

1.

  Check components for any signs of damage or rust.

2.  If damage to any component is detected, DO NOT use the 

fire pit until repairs are properly performed.

Cleaning

This fire pit should be cleaned on a regular basis to promote 

safer experiences and longer product life.

NOTE:

 After repeated use, a slight discoloration of the finish 

may occur.

DO NOT attempt to clean this fire pit until the fire is 

COMPLETELY out and the fire pit has COMPLETELY cooled.

DO NOT use oven cleaner or abrasive cleaners as they will 

damage this product.

DO NOT clean any part of this fire pit in a self-cleaning oven as 

this may damage the finish.

1.

  Wipe exterior surfaces with a mild dish washing detergent 

or baking soda.

2.  For stubborn surfaces, use a citrus-based degreaser and 

a nylon scrubbing brush

3.  Rinse and clean with water.
4.  Remove built-up creosote from components with a 

chimney cleaning product.

Fig. 4

Screen hook

Protective screen

Log grid

5