sunjoe SPX3000-RM, Operator'S Manual

9

m

WARNING! 

Keep hose away from sharp objects. 

Bursting hoses may cause injury. Examine hoses regularly and 

replace if damaged. Do not attempt to mend a damaged hose.

12. Connect the garden hose adapter (female coupler) to 

the water inlet of the pressure washer, then thread your 

garden hose (male end) into the garden hose adapter 

(Fig. 16). The garden hose must have an internal diameter 

of at least 13 mm (1/2 in.) and must be reinforced. The 

water supply must be at least equal to the washer delivery 

capacity.

NOTE: The machine is not suitable for connection to the 

potable water main.

13. Attach garden hose to water supply (Fig. 17).

m

WARNING!

 The intake water temperature must not 

exceed 104ºF/40ºC. The water supply must not exceed  

0.7 MPa.

m

CAUTION!

 The washer must only be used with clean 

water; use of unfiltered water containing corrosive 

chemicals will damage the washer.

14. Make sure the motor switch is pushed to the OFF (0) 

position before plugging the unit into the power outlet  

(Fig. 18).

15. Check that the electrical supply voltage and frequency 

(Volt/Hz) correspond to those specified on the pressure 

washer rating plate. If the power supply is correct, you 

may now plug the pressure washer into the power outlet 

(Fig. 19).

NOTE: 

The GFCI may need to be reset when first plugged 

into the electric outlet. Press the "Reset" button until the 

power light indicator on the GFCI illuminates.

Operation

m

IMPORTANT! 

This pressure washer is equipped with 

a micro-switch sensitive to water flow. This Total Stop System 

(TSS) senses water flow in the pump. When the trigger is 

released, water stops flowing through the pump. The TSS then 

automatically turns the motor off to protect the pump from 

overheating, thus saving energy and prolonging pump life.

1.  Turn the water supply tap on completely.
2.  Make sure the safety lock is down and in its original 

position (Fig. 20), then press the trigger for a few seconds 

until water flow is steady. This will allow air to escape and 

discharge any residual pressure in the hose.

Fig. 16

Water inlet 

(female coupler)

(FRONT)

Garden hose

This end to the 

water inlet on 

the unit

Garden hose  

(male end)

Fig. 17

Connect to water supply

Garden hose

OFF

I

ON

0

OFF

ON

Fig. 18

RESE

T

TEST

Fig. 19

GFCI

Power light 

indicator

Reset