sunjoe SWJ803E-RM, Operator'S Manual

10

4.  To turn the tool ON, push and hold the safety lock button 

(located on the rear handle) with your thumb and then 

squeeze the trigger with your fingers. Once the tool is 

running, you can release the safety lock button (Fig. 16).

5.  To turn the tool OFF, release the trigger switch (Fig. 16).
  NOTE: Do not press the trigger switch until you are ready 

to make a cut.

Adjusting the Telescoping Pole

1.  Disconnect the saw from the power supply. 
2.  Unclip the cam-lock to release the pole (Fig. 17).

3.  Extend the pole to the desired length (Fig. 18). 
  NOTE: Push poles toward each other to shorten the pole 

or pull them away from each other to lengthen the pole. 

Only extend the pole to the minimum length required to 

reach the limb to be cut.

4.  Lock the pole in position by closing the cam-lock (Fig. 19), 

and ensure that the pole is secure. If the pole telescopes 

when the cam-lock is closed, the nut may need tightening.

m

WARNING! 

Failure to lock the telescopic pole cam-lock 

as directed could result in personal injury.

Tightening the Bolt

The retaining bolt may need tightening to secure the telescopic 

pole in place. 

1.  Unclip the cam-lock. Using the hex key wrench, tighten 

the cam-lock nut, then close the cam-lock. Ensure that the 

pole is secure. The wrench may be required to loosen the 

cam-lock nut if you need to adjust the pole to a different 

height (Fig. 20).

Adjusting the Multi-Angle Head

The pole chain saw head can be rotated for different cutting 

angles from 0º to 30º. 

1.  Disconnect the pole chain saw from the power supply. 
2.  Turn the multi-angle head adjustment dial  

counterclockwise to loosen the head (Fig. 21).

Fig. 16

Safety lock button

Trigger 

switch

Cord  

restraint

Fig. 17

Cam-lock

Fig. 18

Telescopic pole

Fig. 19

Cam-lock

Fig. 20

Hex key wrench

Cam-lock nut