Fig.1:
Fit the Base protector (B) onto the Post (A), connect the Post base (C) and post (A) by using bolt (AA)
and flat washer (BB).
Fig.2:
Fix the Conner decor
block (J) onto the top of the post (A) by using bolt (AA) and flat washer (BB).
Fig.3:
Insert the Long panel 1 (D1) into Long panel 2 (D2), fix them by using bolt (CC) and flat washer (BB).
Connect the Short panels (E1 & E2) in the same way.
(Please note the screw position.)
Fig.4:
Fix the Mid top bar connector (I) on the middle of the panels (D1 & D2 / E1 & E2) by bolt (CC) and
washer (BB).
Fig.5:
Fix the long netting bar (O1) to long panels & short netting bar (O2) to short panels by using bolt (AA)
and flat washer (BB).
Fig.6:
Fix the assembled panels to the post (A) by using bolt (DD) and flat washer (BB).
Hardware Pack 2
AA M6*15
bolt 4PCS
BB
M6 flat washer
28 PCS
CC
M6*15 bolt
16 PCS
DD
M6*25 bolt
8 PCS
Please do not tighten
the screws till Fig.6
