Production Number: XXXXXXXX
Made In China
3 / 6
Step 5:
Put the solar umbrella in the sunlight to
charge the batteries before the first use. Make
sure to charge the batteries for at least 8 hours
before the first use. Otherwise it will shorten
lifespan of the batteries and decrease
performance. If charging
the solar panel while attached to the umbrella,
make sure the switch on the pole is in the off
position.
Step 6:
Turn the crank the handle (1) in a clockwise direction to
open the umbrella canopy (A), and in a
counter-clockwise direction to close the umbrella
canopy (A).
You can tilt the umbrella to your desired angle by
pressing the tilt button (2) to release the top of the
umbrella. Release the button (2) to maintain the desired
angle.
Press the light switch (3) on the crank housing to turn
on/off the solar lights. Press once to turn on the rib
lights, press twice to turn on the hub lights, press three
times to turn on both the rib lights and the hub lights,
and press four times to turn all lights off again.
Press the green blue tooth sensor button (4) to turn the
blue tooth speaker on, and there will be a voice prompts
“The blue tooth device is ready to pair”. You must be
within 15 ft of the umbrella to search from your device
for the blue tooth umbrella. Your device will read
“Umbrella BT-SPK”. There will be a voice prompts
“The blue tooth device is connected successfully” when
it is connected successfully. Press the green blue tooth
sensor button (4) to turn the blue tooth speaker off. The
blue tooth speaker will automatically turn off if it
cannot find any devices within 5 minutes. If you need to
turn on the blue tooth speaker again, you need press the
green bluetooth sensor button (4) to turn it on.
Fig . 5
Fig.6:
ATTENTION: You must charge batteries before first use.
Please note that battery can discharge if they are left
unused or uncharged for a long period of time. Since
there can be a six-month period between production and
final customer purchase, we recommend you charge your
solar umbrella for at least 8 hours in direct sunlight
before the first use. Failure to charge the battery will
result in premature dimming of the lights in your new
solar umbrella.
For everyday normal use, turn on the light switch at night
when you want to use solar light and turn off the switch after
use.
NOTE: PLEASE REMOVE THE PLASTIC FILM
ON THE SOLAR PANEL BEFORE CHARGING IN
THE SUN.
NOTE: IF LIGHTS ARE NOT WORKING
PLEASE CHECK BATTERY IN
SOLAR PANEL TO
SEE IF IT HAS BEEN INSERTED PROPERLY.
Attention:
I
f there are more than 2 devices
are within 15ft of the Bluetooth umbrella,
when one device is connected successfully at
first, the other devices will not be connected
successfully.
