Mystic Tan Kyss™
Owner’s Manual
20
Admin Setting
Description
Control Mode
Allows for use of another controller for the booth without the use of the
touchscreen, such as TMAX (TMAX modules may be purchased separately).
Auto Rinse
Begins the rinse cycle once the user exits the booth, without requiring user
interaction.
Auto Reset
Automatically prepares the booth for use after a session, without requiring user
interaction. Also resets the Dirty state when using TMAX.
Closest voltage
Set this value to the closest to the actual voltage from the outlet. Seek
professional assistance if you are uncertain. Options are 208 and 230 volts.
Email session data to:
Select up to two email addresses (no more than two) to receive email
notifications regarding the booth. This will include fault messages. Separate
email addresses with a comma.
Example:
john@email.com, smith@email.com
Serial Number
Displays the booth serial number. Will expedite assistance if calling tech support.
Update from USB
Tap here to update the booth software from a USB. See section
T6: Updating
via USB
for more information.
The Admin Connectivity Page
The Admin Connectivity page is used to establish wireless Internet capability of the booth. The
process is extremely easy, very much like connecting on your personal computer. Remember, to
access any Admin page, you must enter the Admin password.
Admin Date & Time Page
The Admin Date Time page allows an Admin to change the date and time. The Admin may wish
to adjust for time zone after receiving the booth, but time and date will be retained, even after
powering off, once set.
List of Available Networks:
Each network will also
display data such as signal
strength and if the network
requires a password
(denoted by “secure”).
To add the booth to a network,
simply touch the network
name. A keyboard will appear,
and you will be prompted to
enter the network password.
The connections will be
established in a few moments if
the password is correct. If the
password is incorrect, you will
be prompted to enter it again.
Connections will be
retained even after
powering the booth off.
Once the booth powers back
on, it will connect to the last
used network.
Don’t forget the MT Connect and Star icons. It will turn green once a network is successfully
connected. Please allow up to three minutes for the heartbeat to confirm successful communication.
See section T1. Internet Connectivity
if you experience any problems.
