WARNING!
If your wheelchair moves accidentally, please immediately
release the joystick so that the wheelchair will stop moving
automatically unless the joystick is out of order.
CAUTION!
If you connect any devices other than the supplied battery
charger into the socket, causing damage to the control
system,then the warranty is invalid.
CAUTION!
Do not use your wheelchair when the temperature is lower
than -10
℃
or above 50
℃
.
CAUTION!
The charge of 24V/2A supplied by us meets the requirements
mentioned in Section I (
《
General Safety Requirements
》
) of
medical electrical equipment GB9706.1-2007.
6.1.2 Batteries and Its Usage
Fully charge your new battery prior to its initial use. This brings the battery
up to about 90% of its peak performance level; Give the battery another
full charge of 8-14 hours and operate your wheelchair again, the batteries
will now perform at over 90% of their potential; After four or five charging
cycles, the batteries will top off at 100% charge and last for an extended
period. Please replace a new battery when there is a battery failure, and
the old battery must be returned to supplier because of environmental
pollution.
6.
USE, OPERATION
6.1
Use
6.1.1 Controller: It is the key
component of a wheelchair. All
electronics to operate the latter
are housed in it(figure 18).
Usually the controller is installed
in one armrest, which is connected
with motor and battery on power box.
●
Switch button: Switch button supply
the power for control system for
electronic equipment, then equipment
supply the power for motor of wheelchair.
Do not use the switch button to stop the
chair unless an emergency situation.
Otherwise it may shorten the life of the
wheelchair drive components.
●
Joystick: The joystick is mainly used to control
the wheelchair’s movement including its speed
and direction(forward, backward and left or right
etc). The further you push the joystick from its
central position, the faster the wheelchair moves.
Whenever you release the joystick, it will
automatically go back to the center and the brake
will be automatically operative to stop the wheelchair.
●
Horn button: The horn will sound if you press this button.
Speed Up/Down Buttons and Speedometer: After turning on the power,
the speedometer shows the current maximum speed setting. This
maximum speed setting can be adjusted through the speed up button or
speed down button by user.
0 ~ 6 km/h
0 ~ 5.5 km/h
0 ~ 5 km/h
0 ~ 4.5 km/h
0 ~ 4 km/h
LCD
Horn
Speed-up Button
Speed-down
Button
Joystic
On/Off Switch
Unfolding Button
Folding Button
Battery Gauge
Indicator
Rear-speed
Display
Speed Gears
Fault Display
11
12
●
Charger Socket: There are only used to this wheelchair. Do not use the
sockets to supply to other electrical equipment. Otherwise, it may
damage the wheelchair’s control system and its E.M.C performance
(Electromagnetic tolerance).
6. USE, OPERATION
