●
Do not turn on the power switch when sit on the power wheelchair,
and do turn off the power switch when get off from the wheelchair.
Please observe whether the hand brake works or not.
●
Please fold the pedal first then hold the armrest to sit on the
wheelchair; Do not get off the wheelchair by stepping on the pedal.
Otherwise the wheelchair maybe turned over, which is dangerous.
6.2.2 Precautions for operation
●
Find a spacious place like square and have a assistant to help you
practice until you have enough confidence to operate it.
●
Be certain to shut down the power when you up and down the chair,
and set a speed you need through speed adjustment button.
●
We recommend you set the lowest speed until you can operate the
electric wheelchair skillfully.
●
To Practice the stop operation, forward and backward. Push the
handle, the wheelchair move to anywhere you want.
●
Firstly, ensure that it is the lowest speed when practice forward
operation. After you are familiar with it, you can practice “S”
shaped turn. After you are familiar with "S" shaped turn, to practice
backward operation, and pay attention to the speed control setting.
And the backward speed should be lower than forward speed.
6.1.3 Charging Batteries
The battery charger is an important part of the wheelchair. The off-board
charger attached to this product can charge its batteries quickly and easily
to make your wheelchair the best.
Charging the batteries with the off-board charger supplied by us:
■
Be certain the controller is powered off and the wheelchair is in the drive
mode, instead of the manual mode.
■
Connect the 3-pin output plug of the charger to the controller.
■
Connect the power plug of the charger to the standard wall outlet.
■
The red LED on the charger lights indicates that charging is in progress.
The green LED on the charger lights when the batteries are fully charged.
■
We recommend you that the batteries are charged for 8-14 hours.
■
Remove the charger and power plug when fully charged, and put them
into the bag behind the seatback.
6.1.4 Overload Protector
The overload protector, which locates in the battery box,is set for the
wheelchair’s safety. Once motors or batteries overload, the overload
protector will trip to cut off the power. After one or two minutes, it will
automatically reset and then you can continue to drive the wheelchair(fig.15).
6.1.5 Safety Belt
For your safety, the safety belt must be fastened before you drive the
wheelchair(fig.14).
fig.7
fig.8
fig.9
start at
the lowest speed
right
forwatrd
backward
left
fig.14
fig.15
13
14
6.2
Operation
6.2.1 Preparation before operation
6. USE, OPERATION
