© 2021 Sunman (Zhenjiang) Company Limited
。
All rights reserved. Specifications included in this manual are subject to change without notice.
www.sunman-energy.com
version 2021A page2 / 20
TM
2.0 Safety precautions
WARNING: Please read and understand all safety instructions
before installing, wiring, operating, or maintaining modules. DC
power is generated when the module is exposed to sunlight or
other light sources. Direct contact with live parts of the module,
such as terminals, whether connected or not, may result in
personal injury or death.
Safety rules
◼
All installation work must be in full compliance with local regulations and
corresponding national or international electrical standards.
◼
Use insulated tools to reduce the risk of electric shock.
◼
Use appropriate protective measures (slip gloves, overalls, etc.) to avoid direct
contact with workers at 30V DC or higher, while avoiding direct contact with
sharp edges during installation to protect the operator's hands.
◼
Do not wear metal ornaments when installing, to avoid puncturing the modules
and causing electric shock.
◼
If modules are installed or operated on rainy days, strong winds or dew
mornings, appropriate protective measures should be taken to avoid injury to
modules and workers.
◼
Children or unauthorized personnel are not allowed to access the installation
area or module storage area.
◼
If the circuit breaker and overcurrent protection circuit breaker cannot be
opened, or if the inverter cannot be turned off during the module installation
or wiring, cover the array modules with opaque material to stop the power
output.
◼
Do not use or install damaged modules.
◼
If the module surface is damaged or worn, direct contact with the surface of
the module may result in electric shock.
◼
Do not attempt to repair any part of the module, there are no user-accessible
components within the module.
◼
The cover of the junction box should remain closed at all times.
◼
Do not split the modules or move any part of the module.
