56 Broome Corporate Parkway
Conklin, NY 13748 USA
P 877.786.6299 | F 877.786.0329
www.sunmaxxsolar.com
Page 17 of 47
the rear middle leg out and connect it
with the tank brackets.
Attention: Put
two angle irons together as the rear
middle frame and then connect them
with the tank brackets.
The assistant
bars are collected with the reflectors by
the same screw. Take the last rear leg out
and connect it with the tank brackets.
Then use the assistant bars to connect
the rear and front legs in the same way
mentioned above.
with the two adjacent rear legs.
The cross bars can fasten the rear legs
well for fear that the strong wind
destroys the frames.
Fig 7
Fig 8
Step 7.
At last connect the cousins to the
corresponding front and rear legs.
Step 8.
Turn the frame over and put it on
the ground at the installation angle
between the front legs and rear legs.
