4
PART SPECIFICATIONS
This screen presents options for entering a new setup. This information will be found on
workpiece blueprint or by measuring workpieces
Entry in this screen is not require, but when used will provide default values in the setup menu.
Start Diameter
– Enter the start diameter of the workpiece.
Bore Length
– Enter the bore length of the workpiece.
Roughing
– Select this option if stock must be removed to clean up the workpiece.
Finishing
– Select this option if not much stock needs to be removed from the workpiece.
Enable Crosshatch Entry
– Select this option if a specific crosshatch angle is desired in the
workpiece.
Actual Crosshatch
– Displays the honing crosshatch angle, once the Calculate Defaults is
pressed.
Desired Crosshatch
– Enter the desired crosshatch angle, only available when Enable
Crosshatch Entry is selected.
Calculate Defaults
– Press this button to have the software calculate the default honing
parameters based on the part specifications provided.
Function Keys
Main:
To return to the main menu
(Go to Page 2)
.
Setup:
For entering or editing honing parameters
(Go to Page 5)
.