6
RUN MENU
This screen allows you to start a honing cycle.
Coolant (Off/On)
– Toggle coolant on or off.
Stroker (Enabled/Disabled)
– Toggle between stroker enabled or disabled. When enabled
stroker can be moved by joystick control. When disabled stroker can be moved manually by
hand.
Jog Spindle
– Press and hold to slowly rotate spindle.
Dwell
– Press and hold to dwell at any location in workpiece while honing.
Bump Feed
– Press to advance feed while honing.
Feed Active
– Visual indication that feed is active.
Stroker Position
– Displays current stroker position.
Honing Time
– Displays remaining honing time.
Feed Clutch
– Use up and down arrow keys to increase or decrease feed clutch setting. The
higher the setting the fast the feed will advance. Start lower with setting to avoid overshooting
desired spindle load. Then increase value so that desired spindle load can be maintained. Once
value is set for a specific application and desired spindle load it will not need to be changed.