10
ASSEMBLY INSTRUCTION
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
STEP 1:
Attach the
Front Stabilizer (No. 2)
and
Rear Stabilizer (No. 3)
onto the
Main
Frame (No. 1)
, secure with 4
Carriage
Bolts (No. 6)
, 4
Arc Washers (No. 7)
and 4
Domed Nuts (No. 8)
which are
preattached to the stabilizer, tighten
with
Spanner (No. 105)
.
Note:
Ensure that all bolts and washers
are in place and partially threaded in
before completely tightening any of
them.
STEP 2:
A:
Connect the
Lower Sensor Wire
(No. 16)
to the
Upper Sensor Wire (No.
15)
, and then connect
Tension Hook
(No. 17)
with
Tension Cable (No. 10b)
as shown in Diagram A.
Note:
Make
sure
the
Tension
Controller (No. 10a)
is at the lowest
level before you connect the
Tension
Cable (No. 10b)
. This ensures the wires
are
at
their
longest
point.
We
recommend the assistance of a second
person to help hold the
Handlebar Post
(No. 9)
. This will make the connection
easier when you are attaching
Tension
Hook (No. 17)
to
Tension Cable (No.
10b)
.
B:
Remove the preassembled 4
Allen
Bolts (No. 13)
and 4
Arc Washers (No.
14)
from the
Handlebar Post (No. 9)
.
Insert the
Handlebar Post (No. 9)
into
the post of the
Main Frame (No. 1)
;
secure with 4
Allen Bolts (No. 13)
and
4
Arc Washers (No. 14)
that were just
removed
with
Wrench (No. 103)
.
Note
: Ensure that all bolts and washers
are in place and partially
threaded in
before completely tightening any of
them.
