10
ADJUSTMENTS & USAGE GUIDE
FOLDING THE BIKE
Loosen and pull the
Release
Knob (45)
, fold the bike,
and then engage
Release Knob (45)
into one of the
preset holes and tighten
MOVING THE BIKE
First fold the bike according to the instructions above.
To move the bike, hold
Handlebar (No. 84)
and tilt the
bike until the Movable Wheel located on the front
stabilizer end cap touch the ground. With the wheels on
the ground, you can transport the bike to the desired
location with ease.
CLEANING
The bike can be cleaned with a soft clean damp cloth. Do not use abrasives or solvents on plastic
parts. Please wipe your perspiration off the bike after each use. Do not get moisture on the
computer display panel as this might cause an electrical hazard or electronics to failure.
Please keep the bike, especially the computer, out of direct sunlight to prevent screen damage.
Please inspect all assembly bolts and pedals on the machine weekly to ensure they are tightened
properly.
STORAGE
Store the bike in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM
SOLUTION
There is no display on the computer.
1. Verify the wire that comes from the front main
frame is properly connected to the computer.
2. Check if the batteries are correctly
positioned and battery springs are in
proper contact with batteries.
3. The batteries in the computer may be dead.
Change to new batteries.
The bike wobbles when in use
.
Turn the rear stabilizer end cap on the rear stabilizer
as needed to level the bike.
The bike makes squeaking noise when in use.
The bolts may have become loose on the bike.
Please inspect all of the bolts and tighten any
loosened bolts.