Page
- 16 -
of
19
Matters attention and maintenance
1. The controller and the water pump should install not in the place
which drips wet, and pays attention to, the waterproofing moisture-proof,
dustproof.
2. Make sure that various ties meet, only then electrifies the testing.
3. The controller may 24 hour uninterrupted movement, the power loss
be small, only if the solar-powered water heater does not use, then does not
need to close the power source.
4
Typically, magnesium rod should change every 2 year, first open the
PT valve, then shut off the water, open the drain valve, the water inside the
tank emptied, and to do replacement work (must be handled by the relevant
professional maintenance staff ) once be done, need to check if there is any
leaks.
“
WARNING:
IF THE HOT WATER SYSTEM IS NOT USED FOR TWO WEEKS OR MORE, A
QUANTITY OF HIGHLY FLAMMABLE HYDROGEN GAS MAY ACCUMULATE IN THE
WATER HEATER. TO DISSIPATE THIS GAS SAFELY, IT IS RECOMMENDED THAT A HOT
TAP BE TURNED ON FOR SEVERAL MINUTES OR UNTIL DISCHARGE OF GAS CEASES.
USE A SINK, BASIN, OR BATH OUTLET, BUT NOT A DISHWASHER, CLOTHES WASHER,
OR OTHER APPLIANCE. DURING THIS PROCEDURE, THERE MUST BE NO SMOKING,
OPEN FLAME, OR ANY ELECTRICAL APPLIANCE OPERATING NEARBY. IF HYDROGEN
IS DISCHARGED THROUGH THE TAP, IT WILL PROBABLY MAKE AN UNUSUAL SOUND
AS WITH AIR ESCAPING.
“
* Additional instruction *
This product like has the modification not in addition to give the
explanation
