Page
- 17 -
of
19
This is a ¾ (19 mm) to ½ (13 mm) reducing elbow
for the cold water inlet to the tank. We install this
vertically up as pictured.
Hot water outlet from the tank installed
vertically down.
We run copper pipe between the
cold inlets to the hot outlet. A copper T is
installed for the mains cold water line to join into
this copper pipe. It also allows flexibility in
height, and angle for existing mains cold water
lines. N.B. ensure the copper T is located beneath
the Tempering valve, which is also installed on
the copper pipe.
Self explanatory with a ½ copper pipe compression
fitting.
Installed horizontally facing towards the rear of
the tank. This is for ½ copper pipes to lead to the
bottom of the pump.
