6
are & Maintenance
C
Thorough Periodic Cleaning
Introduction
The cooling fan draws air through the canopy and over time will cause a dust build-
up on the lamps and reflectors. This will reduce the tanning effectiveness of the bed.
When a dust buildup is observed, it is necessary to thoroughly clean the inside of
the canopy.
Note!
The canopy can be rotated to a vertical position to aid in cleaning and
relamping. Do not attempt to rotate past this point, as damage will occur.
Warning!
Disconnect sun canopy from electrical power before cleaning.
Cleaning the Canopy
Step 1.
Remove the safety grill and lamps as described in
“
Replacing
Lamps
”
on page 7.
Step 2.
With a soft cloth, wipe the entire length of each lamp to
remove any film build-up.
Step 3.
Wipe the reflectors with a clean damp cloth.
Step 4.
Re-install the lamps and safety grill as described in
“
Replacing
Lamps
”
on page 7.
