2.
Lower all six of the leveling posts (C) until the weight is almost completely
removed from the casters (D). Check the front doors to see if the tops of the doors
are level with each other when closed, it may be necessary to further adjust the lev-
elers. After the unit is level tighten the nuts left loose from Step 1.
HINT:
If you are having difficulty in leveling the booth remember that extending the
right rear leveler will have an opposite effect, i.e., it will tend to lower the right front
of the unit. If necessary adjust the casters under the doors. The door casters should
bear only the weight of the doors. When properly adjusted the doors will open and
close easily. There should be no gap between the doors when closed.
Installation-Assembly
3
C
3.
Connect the electrical connectors at the rear top of the unit. Slide the black split
grommet found in the accessory kit around the wire assembly and then press the
grommet into slot (B). Now mount the white metal cap cover over the connection,
by using two #10x1/4 Phillips screws. Be careful not to crimp, bind or pinch any of
the wires.
4.
Attach the exterior handles to the doors using the pre-installed screws (E).
D
E
