www.sunred.nl
Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.
The switch on the heater head is used to control the three heat setting. (I) for 900w
– (II) for 1200w – (I&II) for
2100w. When the timer is at “ON” position, the heater will be on continuously.
Although the patio heater is shower proof, do not use when raining or in wet conditions.
Always disconnect the power cable from the electrical supply, when the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the outside of the patio heater with a damp cloth. Never
use corrosive or solvent cleaners or immerse in water.
Any maintenance or repairs including replacing the halogen tube should only be carried out by a qualified
electrician or by a recommended service center.
Technical specification
•
Power supply 230V~ 50Hz
•
Wattage max 2100w
•
Net weight 14.6kg
•
Insulation class I
•
Height 210 cm
Assembling Process
Step 1: Fix the Bottom Tube to the base using 3pcs M6*10 bolts.
Step 2: Place the Decoration Cover onto the Bottom Tube.
Step 3: Feed the Power Cord through the Base and the Bottom Tube, and pull through around 2m of cable.
