www.sunred.nl
Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.
The switch on the heater head is used to control the three heat settings. (I) for 900W
– (II) for 1200W – (I&II)
for 2100W. When the timer is in the
“ON” position, the heater will be on continuously.
Although the patio heater is weather proof, do not use when raining or in wet conditions.
Always disconnect the power cable from the electrical supply when the patio heater is not in use.
Care and maintenance
Unplug the unit and let it cool completely.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild
detergent if necessary. After cleaning, dry the unit with a soft cloth.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This
may cause damage or deterioration to the surface of the heater.
Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
Wait until the unit is completely dry before use.
Storage
Ensure the unit is completely cold before storing in a cool, dry location.
To prevent dust and dirt to build-up, use the original packaging to repack the unit.
CHOKING HAZARD:
Store out of reach of children and pets. Contains small parts.
Disposal
DO NOT
dispose of the unit via your weekly household waste collection service. ONLY dispose of this product
at your local, licensed recycling/waste centre.
For further information on the disposal of electrical goods, please contact your local authority.
Trouble shooting
If the heater will not operate, please check the following before seeking repair of service:
Check if the power cord is plugged into an electrical outlet; if not, plug in.
Check if electricity to the main fuse is working.
Make sure the power switches are turned on. If not, choose a heat setting.
Technical specification
•
Power supply 230V~ 50Hz
•
Wattage max 2100W
•
Net weight 14.6 kg
•
Insulation class I
•
Height max 208 cm
Assembly
Step 1: Fix the Bottom Tube to the Base using three M6*50 bolts.
Step 2: Place the Decoration Cover onto the Bottom Tube.
