www.sunred.nl
Operations
1.
Plug in the unit to a socket. Make sure the power supply is same as rated. When press the "On" button on the control panel,
the blue indicator light is flashing, which means it's in standby status.
2.
Press button "On" on the control panel or the remote controller to switch on the heater. Then the blue indicator light is on.
3.
To switch off the heater, press the button "Off" on the control panel of the heater. When press the "Off" button on the control
panel of the heater, the blue indicator light is off, and the remotrol is unfunctional. To press "Off" button on the remote control
will only swift the appliance into standby status, and the blue indicator light is flashing.
Cautions
1.
The unit must be placed with the clearance of 100cm to the wall and 30cm to the ceiling .
2.
The heater must be installed at least 1,8m above the floor.
3.
The unit must be securely placed on a horizontal and flat surface.
4.
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur when
touching it during this period.
5.
Don't place the unit close to curtain and/or other flammable objects. Otherwise there will be a danger of catching fire.
6.
Dont' cover the unit with anything during operation or a short time after it's shut down.
7.
Don't wrap the power supply cord on the unit.
8.
The unit must be handled with care, and avoid of vibration or hitting.
9.
The unit must be securely grounded during operation.
10. When damaged, the unit must be repaired by professional reparing team.
11. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
12. The heater must not be located immediately below a socket-outlet.
13. When assembling, keep clear from any board or flammable material.
14. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
15. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
16. Children should be supervised to ensure that they do not play with the appliance.
17. The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flammable
dust.
18. The head of the unit is at high temperature during operation. Unplug the unit and wait till it's cool before cleaning.
19. Don't use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
20. Don't use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
21. Don't use this unit as a cloth drier or towel drier.
22. Dont' use this unit as a sauna heater.
23. Don't use this unit as a room heater of heat storing.
24. Don't use this unit in place of animal propagating and raising.
25. Don't use this unit in heating system of hot air centre.
26. Don't immerse this unit into water for cleaning.
27. The unit should be plugged in a socket, which is easily visible and reachable.
28. Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
the first few minutes after it's turned on. This is normal, and may not affect the performance of the unit
29. Children of less than 3 years should be kept away unless continuously supervised.
30. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug
in, regulate and clean the appliance or perform user maintenance.
Cleaning
Unplug the unit before cleaning. It should be wiped with wet cloth. Don't use too much water.
