MN5000000072
Page 9
# lsmod | grep igb
# ifconfig –a
If there is a device name, ethX, shown on the monitor, the linux
driver is load. Then, you can use the following command to
activate the ethX.
# ifconfig ethX up, where X=0,1,2,…
Chapter 3: Troubleshooting Tips
The computer can NOT detect the PCIe Dual Port Gigabit Server
Adapter
1.
Make sure that the PCI Express card is correctly plugged into
the PCI Express slot; if not, turn off the computer and plug it
again.
2.
If the PCI Express card is plugged in correctly, see if the
golden connectors on the card are clean; if not, clean the
connector surface.
3.
If still NOT, please change another PCI Express slot on your
motherboard.
