107
•
Because
Absolute (position)
will be needed to make sure the score lines and the cut lines end up aligned
properly, you may want to move your project to the lower right corner of the
Drawing Area
, close to the
origin you’ll use on the material:
•
Click on the thumbnail for the score lines since that layer should always be executed first. In the
Send to be
Cut
window, check
Absolute (position)
and verify that
Assign Tools by Color
is not marked:
•
Click on the
Cutter Control
tab and enter appropriate settings for scoring your material. In this case,
cardstock is being scored:
Cut lines are on one layer
Score lines are on another layer
Check the box for
Absolute
(position)
Uncheck the box for
Assign Tools
by Color
Uncheck
Blade
Offset
Enter settings for scoring
Set
Passes
for scoring
