22
•
In the prior screenshot, the
IP Address
is already set to the correct
Stand-Alone IP Address:
192.168.16.254. If this matches what you see, skip the next two steps. Otherwise, click on
Configure
and
the following window opens:
•
Change the
IP Address
to 192.168.16.254. Click on
Test
. A
Port OK
message should pop up. Click on
OK
and then click on
Apply
:
•
The
IP Address
should now appear in the
Vinyl Spooler
window. Click on
Done
and proceed to
Section
1.13
. Remember that your computer will not have access to the Internet or other network devices while in
Wireless Stand-alone
mode.
Should read
SKYCUT C16
Select
Windows
Port
Click on
Configure
Select
Port
Check to see if this is
already set
Enter the following
IP Address
Click on
Test
Click
OK
Click on
Apply
