23
B. The Skycut has previously been connected to a network
•
On the Skycut’s control panel, select
Set
and then select
Wifi.
The
Wifi screen
will appear:
•
To reset the Skycut so that it will be found as an available network, press and hold the
Default
button for 3
seconds. Release and you should see the
Apply
button now displays
Wait
.. In a minute the
Apply
should
return and you can then proceed back to
A
.
The Skycut has never been set up wirelessly to a network
and
use the same procedure as if the Skycut was never set up on a network.
1.12.4 USB Flash Drive
•
With a USB Flash Drive connection, you will normally follow the steps presented in this section. If you are
new to SignMaster and/or to your Skycut, it is recommended that you go to
Section 1.13
now and set up a
file using the steps presented there. Then, when you are ready to cut, return to this section.
•
Insert a USB flash drive into your computer and allow Windows to find it. Note the drive letter assigned by
Windows.
•
Design or open a file in SignMaster. After making any changes to the design, click on the
Cut, Plot &
Engrave Tools
icon
(6
th
from the left on the upper middle task bar) and select
Vinyl Spooler.
In the
window which opens, click on the
Connection
tab and make the following changes:
Should read
SKYCUT C16
Select
Windows
Port
Select
Port
Press and hold
Default
Click on
Wifi
